Follow this operation manual.
Steller applicable model and motherboard version
Printer model: CR-6 MAX
Software version v2.0.1.2
Motherboard silk print HW4.5.3 (1.1.0.3)
illustrate:
The heating range of the firmware is limited to 90 ° C and the version is raised to the basic version of Marlin2.0.6
Screen update instructions:
1. Format the TF card on the computer, and select 4096 to allocate the size of the unit.
2. Put dwin_set into the memory card.
3. Turn off the printer and insert the memory card into the screen card slot.
4. Restart and wait for the update.
5. After completing the update, remove the TF card and delete the file inside.
Motherboard update:
1. Format the TF card on the computer, and select 4096 to allocate the size of the unit.
2. Put the firmware file "CR-6 MAXMARLIN2.0.6V4.5.3V2.0.1.2.bin" into the memory card (this step is necessary, please note).
3. Turn off the printer and insert the memory card into the machine card slot.
4. Restart and wait for the update.
5. After completing the update, take out the TF card and delete the bin file inside.
CR-6 Max-Marlin2.0.1-HW-V4.5.3-SW-V1.0.1