Ender-3 V3 Plus
فيديوهات
معامل
تحميل
مركز المساعدة
خدمة المنتج
المعاملات
Core Specifications
Supported Filaments
PLA, TPU(95A), PETG, ABS, PLA-CF, PETG-CF, CR-carbon
Filament Diameter
1.75 mm
Heatbed Temperature
≤ 100 °C
Nozzle Temperature
≤ 300 °C
Nozzle Material
Nozzle Diameter
0.4 mm
Hotend Material
Extruder
New high-speed direct drive extruder
Motion System
CoreXZ
Acceleration
≤20000 mm/s²
Printing Speed
≤600 mm/s
Layer Height
0.1-0.35mm
Printing Accuracy
100±0.1 mm
Printing Technology
FFF
Supported Filaments
PLA, TPU(95A), PETG, ABS, PLA-CF, PETG-CF, CR-carbon
Filament Diameter
1.75 mm
Heatbed Temperature
≤ 100 °C
Nozzle Temperature
≤ 300 °C
Nozzle Material
Nozzle Diameter
0.4 mm
Hotend Material
Extruder
New high-speed direct drive extruder
Motion System
CoreXZ
Acceleration
≤20000 mm/s²
Printing Speed
≤600 mm/s
Layer Height
0.1-0.35mm
Printing Accuracy
100±0.1 mm
Printing Technology
FFF
Functionality
Lighting Kit
RFID Sensor in Printer
Air Filter
Chamber Temperature
Auto Filament Relay
Power Loss Recovery
Filament Run-Out Sensor
Rated Power & Voltage
Remote Control
Display Screen
HD Color Touch Screen
AI Camera for Calibration (Timelapse supported)
Al Camera for Monitoring (Timelapse supported)
Input Shaping
Yes (G-sensor included)
Leveling Mode
Auto Leveling
Lighting Kit
RFID Sensor in Printer
Air Filter
Chamber Temperature
Auto Filament Relay
Power Loss Recovery
Filament Run-Out Sensor
Rated Power & Voltage
Remote Control
Display Screen
HD Color Touch Screen
AI Camera for Calibration (Timelapse supported)
Al Camera for Monitoring (Timelapse supported)
Input Shaping
Yes (G-sensor included)
Leveling Mode
Auto Leveling
Show More
عرض الكل
تحميل
مركز المساعدة
الأسئلة الشائعة
أسئلة عامة
What should I do if the hot bed cannot be heated？
Check whether the heating wire of the hot bed is damaged or the interface is loose, re-reinforce or replace with a new wiring; It can be tested whether the resistance of the hot bed is normal, the resistance = the square of voltage/power;
Other filaments can be printed well by Ender-3 v3 Plus, except for ABS filament. Why does it not stick only when printing ABS?
Does the Ender-3 V3 Plus support automatic bed leveling?
What type of extruder does the Ender-3 V3 Plus?
عرض الكل
خدمة المنتج
عرض الكل