Ender-3 V3 Plus
동영상
매개변수
다운로드
도움말 센터
제품 서비스
매개변수
Core Specifications
Printing Technology
FFF
Printing Accuracy
100±0.1 mm
Layer Height
0.1-0.35mm
Printing Speed
≤600 mm/s
Accelaration
≤20000 mm/s²
Motion System
CoreXZ
Extruder
New high-speed direct drive extruder
Hotend Material
Nozzle Diameter
0.4 mm
Nozzle Material
Nozzle Temperature
≤ 300 °C
Heatbed Temperature
≤ 100 °C
Filament Diameter
1.75 mm
Supported Filaments
PLA, TPU(95A), PETG, ABS, PLA-CF, PETG-CF, CR-carbon
Printing Technology
FFF
Printing Accuracy
100±0.1 mm
Layer Height
0.1-0.35mm
Printing Speed
≤600 mm/s
Accelaration
≤20000 mm/s²
Motion System
CoreXZ
Extruder
New high-speed direct drive extruder
Hotend Material
Nozzle Diameter
0.4 mm
Nozzle Material
Nozzle Temperature
≤ 300 °C
Heatbed Temperature
≤ 100 °C
Filament Diameter
1.75 mm
Supported Filaments
PLA, TPU(95A), PETG, ABS, PLA-CF, PETG-CF, CR-carbon
Functionality
Leveling Mode
Auto Leveling
Input Shaping
Yes (G-sensor included)
Al Camera for Monitoring (Timelapse supported)
AI Camera for Calibration (Timelapse supported)
Display Screen
HD Color Touch Screen
Remote Control
Rated Power & Voltage
Filament Run-Out Sensor
Power Loss Recovery
Auto Filament Relay
Chamber Temperature
Air Filter
RFID Sensor in Printer
Lighting Kit
Leveling Mode
Auto Leveling
Input Shaping
Yes (G-sensor included)
Al Camera for Monitoring (Timelapse supported)
AI Camera for Calibration (Timelapse supported)
Display Screen
HD Color Touch Screen
Remote Control
Rated Power & Voltage
Filament Run-Out Sensor
Power Loss Recovery
Auto Filament Relay
Chamber Temperature
Air Filter
RFID Sensor in Printer
Lighting Kit
Show More
모두 보기
다운로드
도움말 센터
FAQ
일반 질문
What should I do if the hot bed cannot be heated？
Check whether the heating wire of the hot bed is damaged or the interface is loose, re-reinforce or replace with a new wiring; It can be tested whether the resistance of the hot bed is normal, the resistance = the square of voltage/power;
Other filaments can be printed well by Ender-3 v3 Plus, except for ABS filament. Why does it not stick only when printing ABS?
Does the Ender-3 V3 Plus support automatic bed leveling?
What type of extruder does the Ender-3 V3 Plus?
모두 보기
제품 서비스
모두 보기